bridges (18) campsite (28) cartoons (15) centenary (3) discussion (5) experimental (51) gadgets (23) gateways (12) lashings (21) models (9) raft (84) resources (27) sculpture (16) software (22) techniques (42) towers (45) trebuchets (5) treehouses (17) tutorial (9)

August 19, 2016

Cardboard box rafts- Akela 2016

At the recent Akela 2016 camp, I was involved in running outdoor activities for the Pack Scouters, alongside the community service and crafts bases that were run. Alongside a tensegrity cube, I ran this challenge- to build a raft using staves, light cord, cardboard boxes and dustbin bags, and float a member of their team across a swimming pool (around 10 metres/ 30 feet).
Photographs courtesy Marissa Rakic


The idea is to build the cardboard boxes up, then seal them in plastic bags, and use these boouyancy 'blocks' tp build a raft. In practice, of the three teams who attempted it, only one got their 'sailor' safely across the pool. Here are the two unsuccessful teams at their moment of immersion:

The first team built a raft that had good, solid boxes, well tied together. However, they built a narrow raft which had very poor stability, and despite a few attempts, the raft was unable to remain upright.
The second team distributed the bouyancy more evenly, but one of their boxes failed around halfway through:
 The third team, pictured at the top of the post, managed to get across without any incident. I allocated 45 minutes for this, and all three teams had sufficient time, even allowing for around half the team being unfamiliar with raft building. I can recommend this as a patrol challenge if the weather is good. I would suggest having a full set of boxes for each team- in the event that a box gets wet, it is almost impossible to re-use.

No comments: